![]() This property is initially set according to the user's settings (found in Preferences → Part design → General → Model settings). Cleans up residual edges left after the operation. Data Up To Face: A face the pocket will extrude up to, see Options.Otherwise and if Data Use Custom Vector is used, it is measured along the custom direction. Data Along Sketch Normal: introduced in version 0.20 If true, the pocket length is measured along the sketch normal.Data Direction: introduced in version 0.20 Vector of the pocket direction if Data Use Custom Vector is used.Data Use Custom Vector: introduced in version 0.20 If checked, the pocket direction will not be the normal vector of the sketch but the given vector, see Options.Data Length2: Second pocket length in case the Data Type is TwoLengths, see Options.Data Length: Defines the length of the pocket, see Options.Data Type: Type of ways how the pocket will be extruded, see Options.This is done to facilitate the design of molds and molded parts. ![]() Note that inner structures receive the opposite taper angle. ![]() This option is only available if Type is Two dimensions. A positive angle means the outer pocket border gets wider. Tapers the pocket in the opposite extrusion direction by the given angle. Multiple units can be used independently of the user's units preferences (m, cm, mm, nm, ft or ', in or ").
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |